- +91-9840086688
- rajesh@fouressgroup.in
.png)
Find below the search results for the material you've specified. Please note here this information is NOT to be used for design purposes, and in no event shall MSO be liable for any damages arising from the misuse of this information.
Below is a comprehensive list of our alloys arranged by type. More detailed information can be found on each alloys specific page. All of our products are purchased to normal industry standards and come with material test reports (MTR) also known as material certifications.
This alloy of nickel-copper is resistant to sea water corrosion as well as to a variety of acids and other corrosive media.
Marine fixtures, pumps, valves and piping systems for sea water application. Because of its good corrosion resistance it is also used in chemical plant equipment.
Conventional machining techniques used for iron based alloys may be used. This alloy does work-harden during machining and has higher strength and "gumminess" not typical of steels. Heavy duty machining equipment and tooling should be used to minimize.
This alloy has good ductility and may be readily formed by all conventional methods. Because the alloy is stronger than regular steel it requires more powerful equipment to accomplish forming. Heavy-duty lubricants should be used during cold forming.
Resists corrosion from water, including sea water, and resistant to chloride stress-corrosion cracking. Good corrosion resistance to sulfuric acid, hydrochloric acid, hydrofluoric acid, and alkalis.
The commonly used welding methods work well with this alloy. Matching alloy filler metal should be used. If matching alloy is not available then the nearest alloy richer in the essential chemistry (Ni, Co, Cr, Mo) should be used. All weld beads should
Not heat treatable, but may be annealed after cold working.
No data, however the alloy is readily forged.
No data, but the alloy may be hot worked.
Cold forming may be done using standard tooling although plain carbon tool steels are not recommended for forming as they tend to produce galling. Soft die materials (bronze, zinc alloys, etc.) minimize galling and produce good finishes.
Annealing may be done at 1700 F. A stress-relief anneal may be done at 1050 F for 1 to 2 hours, followed by slow cooling.
Hardens due to cold work only.
Copyright 2019. SSSS Pvt. Ltd.